Ningbo Qiaopu Electric Co., Ltd. plug molding operation matters

A Ningbo Qiaopu Electric Co., Ltd. molding operation precautions:
⑴ attention to the power cord color injection molding of plastic materials and note whether the color line drawings. At.
⑵ machine is running against the hand or other objects into the mold ⑶ attention on the quality of a process and, if negative phenomena, immediately to the supervisor to reflect.
⑷ product must be self-removed, see to pick out bad products, and rework time, there are special problems need to the higher authorities.
⑸ not both simultaneously a machine to avoid accidents.
⑹ emergency press the emergency stop switch.
⑺ prohibits hand or other body parts close to the operation of the machine parts.
Second, the self-test method:
A bit like the surface of the material, charred, silver, water lines, air bubble, deformation, lack of material, color, weld lines, flash, dislocation, color separation, wire crushed, exposed copper wire, wire, wire exposed too long or too short, shrink, mold using the wrong model, SR direction of the anti-, SR lifting is not enough; are ill.
Third, machine maintenance:
⑴ every morning before starting the lubrication.
⑵ always wipe the surface of machine oil, clean the table to keep clean.
⑶ timely repair of the faulty machine, and a daily record of maintenance and repair of the "machine maintenance card."